Varnishing the wing

Post a reply

Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:

BBCode is ON
[img] is ON
[flash] is OFF
[url] is OFF
Smilies are ON

Topic review
   

Expand view Topic review: Varnishing the wing

Re: Varnishing the wing

by mmarien » Tue Jul 18, 2017 8:54 pm

Done :D

Re: Varnishing the wing

by orchardair » Tue Jul 18, 2017 12:24 pm

Just fixing the spelling on the Subject line for easier future searching.
Thanks for the post!

Re: Vanishing the wing

by mmarien » Mon Jul 10, 2017 12:08 pm

Thanks guys. I was looking over the wing the other days and it looked like a lot of work to remove the fittings just to do a cleaner varnish job. Perhaps a little patience is all that is needed. I'll probably have to use clear coat for everything as I don't think I can get spar varnish in Canada.

Re: Vanishing the wing

by HC85 » Fri Jul 07, 2017 6:03 am

Hi Murray, I did not remove the fittings. I used Stits epoxy spar varnish for the majority of the wings, and also applied two coats under the fittings prior to installing them for the final time. The Stits stuff "wicks" well into the wood, I used the system 3 clear coat on the ribs after constructing them, paying close attention not to coat the areas that would be glued later. I think either product works well. I didn't worry too much about getting the spar varnish on the flat fittings, I just tried to be as neat as possible. I didn't think it would hurt to seal the edges of the fittings either if I happened to bump up against them when I varnished.

Rick

Re: Vanishing the wing

by Bitshifter » Tue Jul 04, 2017 5:25 pm

I used clear coat on all the areas that fabric glue would contact. I also did the spars and the areas under the compression struts and wing fittings, this was mostly to control rot. I used spar varnish on the ribs. I brushed everything on.

Varnishing the wing

by mmarien » Mon Jul 03, 2017 9:40 pm

The forum got a little slow so I though I would post a question. I'm working on the second wing and thinking about varnishing them. I will probably use System 3 Clear Coat. I used it on the center section. I clear coated all the ribs as I made them. I left the spar holes and front edge unvarnished as they needed to be glued.

So the question, did anyone remove the fittings before the varnished the wings? I varnished under the fittings but was thinking they will look nicer if they are not splashed with clear coat. Not that anyone will see them under the fabric.

By the way, Happy fourth of July. We celebrated Canada's 150th here on Saturday.

Top